甘孜频秸电子科技有限公司

Responsibilities:
- Further development of protection relay offers within the scope of product maintenance.
- focuses on performing the design of a part of an Electronics Hardware solution, verifying the design through tests and prototypes production.
- contribute to defining the specification and architecture of new products and sub-assemblies.
- Fault analysis on electrical assemblies
- Selection of suitable replacement parts for obsolete or unavailable electronic components
- Circuit diagram creation/modification with ECAD tools (Candence preferred)
- Capable of working autonomously with minimal supervision, demonstrating a higher degree of self-reliance and responsibility.
- Internal communication/ coordination with mechanical design, PCB layout, quality department, purchasing and industrialization.
- Participation in national and international project and team meetings


Requirements:
- Embedded system design capability
- Experience with MPU hardware system design.
- Experience with DDR, LPDDR, NAND, Norflash, EEPROM interface design.
- Experience with PMIC, DCDC, LDO design.
- Experience with Ethernet communication design.
- Experience with analogue chain and data transfer design.
- Experience with serial port and CAN interface.
- Experience with isolation design.
- Familiar with solving EMC/EMI related issue.
- Experience with PCB gerber release and PCBA manufacture.
- Strong lab skills with hands on soldering components, operating oscilloscopes, logic analyzers, spectral analysis etc.
- Knowledge of FPGA design is a plus.